Do some preparation work for compiletest check-cfg
This PR does several preparation work for having always-on check-cfg in compiletest.
In particular, this PR does two main things:
- It unifies all the *always-false* cfgs under the `FALSE` cfg (as it seems to be the convention under `tests/ui`)
- It also removes some useless conditions
This is done ahead of the introduction of the always-on check-cfg in compiletest to reduce the amount of changes in that follow-up work. I also think that this is useful even without that follow-up work.
[Test] issue-122805.rs should limit to little endian target
In issue-122805.rs, codegen on big endian target is different from little endian target.
```llvm
%0 = load <8 x i16>, ptr %value, align 2
store <8 x i16> %0, ptr %_0, align 1
ret void
```
This is expected since the conversion is unnecessary on BE target for this case.
The actual ABI implication here is that in some cases the values
are required to be "consecutive", i.e. must either all be passed
in registers or all on stack (without padding).
Adjust the code to either use Uniform::new() or Uniform::consecutive()
depending on which behavior is needed.
Then, when lowering this in LLVM, skip the [1 x i128] to i128
simplification if is_consecutive is set. i128 is the only case
I'm aware of where this is problematic right now. If we find
other cases, we can extend this (either based on target information
or possibly just by not simplifying for is_consecutive entirely).
When passing a 16 (or higher) aligned struct by value on ppc64le,
it needs to be passed as an array of `i128` rather than an array
of `i64`. This will force the use of an even starting register.
For the case of a 16 byte struct with alignment 16 it is important
that `[1 x i128]` is used instead of `i128` -- apparently, the
latter will get treated similarly to `[2 x i64]`, not exhibiting
the correct ABI. Add a `force_array` flag to `Uniform` to support
this.
The relevant clang code can be found here:
fe2119a7b0/clang/lib/CodeGen/Targets/PPC.cpp (L878-L884)fe2119a7b0/clang/lib/CodeGen/Targets/PPC.cpp (L780-L784)
I think the corresponding psABI wording is this:
> Fixed size aggregates and unions passed by value are mapped to as
> many doublewords of the parameter save area as the value uses in
> memory. Aggregrates and unions are aligned according to their
> alignment requirements. This may result in doublewords being
> skipped for alignment.
In particular the last sentence.
Fixes https://github.com/rust-lang/rust/issues/122767.
compiletest: properly handle revisioned run-rustfix tests
Before this PR, if you have a revisioned `//@ run-rustfix` test like `//`@[foo]` run-rustfix`, you would run into an error saying crate name cannot contain `.` characters because the fixed test file trying to be compiled is named `<test-name>.<revision>.fixed`, from which `rustc` infers the crate name to be `<test-name>.<revision>` which is not a valid crate name.
This PR fixes the problem by constructing a synthetic crate name from `<test-name>.<revision>`, by
1. replacing all `-` with `_`, and
2. replacing all `.` with `__`
and pass that constructed crate name with `--crate-name` to rustc to compile the fixed file.
Fixes https://github.com/rust-lang/rust/issues/123596.
Rollup of 2 pull requests
Successful merges:
- #123584 (Emit an error when `rustc_doc_primitive` has an unknown value)
- #123589 (sys_common::thread_local_key: make a note that this is not used on Windows)
r? `@ghost`
`@rustbot` modify labels: rollup
sys_common::thread_local_key: make a note that this is not used on Windows
This just confused me for a while. I don't have the time to clean it up but I can at least leave a note for the next wary traveler.
Use unchecked_sub in str indexing
https://github.com/rust-lang/rust/pull/108763 applied this logic to indexing for slices, but of course `str` has its own separate impl.
Found this by skimming over the codegen for https://github.com/oxidecomputer/hubris/; their dist builds enable overflow checks so the lack of `unchecked_sub` was producing an impossible-to-hit overflow check and also inhibiting some inlining.
r? scottmcm
This particular cast appears to have been copied over from clang, but there are
plenty of other call sites in clang that don't bother with a cast here, and it
works fine without one.
For context, `llvm::Intrinsic::ID` is a typedef for `unsigned`, and
`llvm::Intrinsic::instrprof_increment` is a member of
`enum IndependentIntrinsics : unsigned`.
Save/restore more items in cache with incremental compilation
Right now they don't play very well together, consider a simple example:
```
$ export RUSTFLAGS="--emit asm"
$ cargo new --lib foo
Created library `foo` package
$ cargo build -q
$ touch src/lib.rs
$ cargo build
error: could not copy
"/path/to/foo/target/debug/deps/foo-e307cc7fa7b6d64f.4qbzn9k8mosu50a5.rcgu.s"
to "/path/to/foo/target/debug/deps/foo-e307cc7fa7b6d64f.s":
No such file or directory (os error 2)
```
Touch triggers the rebuild, incremental compilation detects no changes (yay) and everything explodes while trying to copy files were they should go.
This pull request fixes it by copying and restoring more files in the incremental compilation cache
Fixes https://github.com/rust-lang/rust/issues/89149
Fixes https://github.com/rust-lang/rust/issues/88829
Related: https://internals.rust-lang.org/t/interaction-between-incremental-compilation-and-emit/20551
