Fix SPEEDTEST instructions and output
* `--nocapture` hasn't been needed anymore since forever (even before `ui_test`)
* the result was dividing by 1000 instead of the number of test runs, giving bogus (but still useful for the purpose) timing results.
changelog: fix SPEEDTEST instructions and output
It lints against features that are inteded to be internal to the
compiler and standard library. Implements MCP #596.
We allow `internal_features` in the standard library and compiler as those
use many features and this _is_ the standard library from the "internal to the compiler and
standard library" after all.
Marking some features as internal wasn't exactly the most scientific approach, I just marked some
mostly obvious features. While there is a categorization in the macro,
it's not very well upheld (should probably be fixed in another PR).
We always pass `-Ainternal_features` in the testsuite
About 400 UI tests and several other tests use internal features.
Instead of throwing the attribute on each one, just always allow them.
There's nothing wrong with testing internal features^^
Currently, Clippy, Miri, Rustfmt, and rustc all use an environment variable to
indicate that output should be blessed, but they use different variable names.
In order to improve consistency, this patch applies the following changes:
- Emit `RUSTC_BLESS` within `prepare_cargo_test` so it is always
available
- Change usage of `MIRI_BLESS` in the Miri subtree to use `RUSTC_BLESS`
- Change usage of `BLESS` in the Clippy subtree to `RUSTC_BLESS`
- Change usage of `BLESS` in the Rustfmt subtree to `RUSTC_BLESS`
- Adjust the blessable test in `rustc_errors` to use this same
convention
- Update documentation where applicable
Any tools that uses `RUSTC_BLESS` should check that it is set to any value
other than `"0"`.
- Add clippy_dev to the rust workspace
Before, it would give an error that it wasn't either included or
excluded from the workspace:
```
error: current package believes it's in a workspace when it's not:
current: /home/joshua/rustc/src/tools/clippy/clippy_dev/Cargo.toml
workspace: /home/joshua/rustc/Cargo.toml
this may be fixable by adding `src/tools/clippy/clippy_dev` to the `workspace.members` array of the manifest located at: /home/joshua/rustc/Cargo.toml
Alternatively, to keep it out of the workspace, add the package to the `workspace.exclude` array, or add an empty `[workspace]` table to the package's manifest.
```
- Change clippy's copy of compiletest not to special-case
rust-lang/rust. Using OUT_DIR confused `clippy_dev` and it couldn't find
the test outputs. This is one of the reasons why `cargo dev bless` used
to silently do nothing (the others were that `CARGO_TARGET_DIR` and
`PROFILE` weren't set appropriately).
- Run clippy_dev on test failure
I tested this by removing a couple lines from a stderr file, and they
were correctly replaced.
- Fix clippy_dev warnings
